Answering questions when using the Yaman HRF 10T facial massage machine

Skip to main content in article(see)

Yaman skin care machine is good, knowing how to use it properly will be even better. Please learn and follow the correct way to use the Yaman HRF 10T machine below to maximize the skin care capabilities of this machine!

1. How to use the Yaman HRF 10T facial massage machine

1.1. Overview of the functions of the Yaman HRF 10T machine

RF radio wave technology is a technology that uses dual circular wave rings to help the skin be heated deeply and widely, helping to expand pores faster than conventional massage.

RF Cleansing is the machine’s cleaning mode. RF technology combined with the release of beneficial ions helps completely remove dirt hidden deep in the hair roots.

RF Moisture is a moisturizing mode. RF waves will both radiate heat and help push nutrients deeper, making them easily absorbed into the skin.

RF EMS is a training regimen for the skin. RF waves and EMS waves help stimulate facial muscles to exercise, melt fat, and increase skin elasticity.

RF LED is a mode that promotes collagen formation under the skin, reduces signs of sagging and wrinkles, and makes skin firmer.

COOL is the cooling mode and also the mode that ends the machine’s beauty process. Rapidly cooling skin helps shrink pores, retaining the necessary amount of moisture and nutrients inside the skin.

1.2. Instructions for using the Yaman HRF 10T machine with cleaning mode

With Clean mode, first you need to insert makeup remover cotton into the face of the machine. Need to wet the cotton with toner or lotion then press the MODE button on the machine body to set Clean mode. The level button will allow you to adjust the cleaning level from 1 to 5. When the machine is operating, move the machine to the skin area that needs to be cleaned. Note that when moving the machine, you need to move it from bottom to top and from the bottom up. inside and outside skin.

1.3. Use ionic mode to clean and moisturize

If your moisturizer is water-based, you can do the same steps as you did in Clean mode, the makeup remover cotton pad will absorb the moisturizer and penetrate into your skin thanks to the MOISTURE mode on the button. MODE. You can set the moisturizing level from 1 to 5 depending on your needs. If you use cream or gel moisturizer, you can apply it first on your face and then massage directly into the surface of the device without needing makeup remover cotton.

1.4. Using EMS mode helps tighten facial skin

In EMS mode, you should apply serum to your face first and then start the machine’s EMS UP mode via the MODE button. You can adjust the level from 1 to 5, and note that you should not move the machine continuously like the previous 2 modes, but need to press and hold the machine in 1 position for about 3 seconds and then move to a new position.

1.5. Use LED mode to moisturize skin from within

You should choose anti-aging and wrinkle-reducing creams used in this step. Similar to EMS mode, after applying the cream, turn on the machine’s LED mode and move it across your face in the direction of facial lifting massage.

1.6. Use Cool mode to tighten pores

After performing the 5 steps above, switch to COOL mode to tighten pores and lock in moisture. In this step, you also do not move the machine continuously, just hold the machine and gently press in one position for 3 seconds so that the machine penetrates deeply into the skin. Do the same for other positions and apply to the whole face. COOL is also the final step in using the Yaman HRF 10T machine.

2. Answer questions when using the Yaman HRF 10T facial massage machine

2.1. You should use the Yaman HRF 10T several times a week

Skin care is a daily task, but you should only use the Yaman HRF 10T for deep care 2 to 3 times per week. This is the amount of time needed for the skin to recover and fully absorb the nutrients that have been absorbed. On days when you don’t use Yaman, you can take care of your skin in the usual way or combine it with other skin care products.

2.2. Who should use the Yaman HRF 10T skin care machine?

Anyone can use the Yaman HRF 10T skin care machine, but according to recommendations, women aged 25 years and older are the most suitable subjects. At this age, the skin will begin to age and women should take care of it right from this time before the signs become more serious.

2.3. How much lotion should I use each time I use Yaman HRF 10T?

The amount of cream used each time depends greatly on your skin condition. You can rely on the instructions of the cream manufacturer to know what is suitable for you.

2.4. Is the Yaman HRF 10T waterproof?

As an electrical device, you should not expose the Yaman HRF 10T to water to prevent short circuits and fires. The machine may malfunction if it comes into contact with water. You should keep it in a dry place and only use a damp cloth to clean the machine.

2.5. Is it okay for my skin to be slightly red after using the Yaman HRF 10T machine?

The Yaman HRF 10T machine uses RF radio wave technology to heat the skin, a series of deep cleaning steps, and stimulate the muscles on the face to move, leading to red skin. This is a very normal skin reaction after a course of treatment.

2.6. No warm feeling when using RF mode of Yaman HRF 10T machine

Yaman’s RF mode will radiate heat at the tip of the device in contact with the skin. If you do not feel warm when using this mode, you can try adjusting the Level button on the camera body or resetting the device. If you still do not see any response from the device, please contact the supplier because this may be a product error.

Yaman HRF 10T is the Yaman skin beauty machine – Japan’s number 1, worth investing in. Mastering how to use the Yaman HRF 10T machine will help make your machine’s efficiency even better. Don’t forget to combine moisturizers, skin-softening creams, anti-aging creams… that are safe to nourish the skin.