Fix water purifier that won't shut off at home easily
ORCID iD icon https://orcid.org/0009-0009-1599-2739

Fix water purifier that won’t shut off at home easily

Skip to main content in article (See)

A water purifier running without stopping is one of the basic operating errors. Let’s find out the cause and how to fix it with Websosanh.

Water purifier is an important device for many families today. With the task of providing pure water, water purifiers are gradually becoming popular. When in use, machines may encounter some errors or problems. Water purifiers that run continuously cause energy consumption and waste of natural resources. Some simple home remedies that you should know.

What is the phenomenon of the water purifier running without stopping?

Normally, water purifiers operate from 15 to 45 minutes. The machine can operate for a maximum of 1 hour and then automatically shuts off the water. Some modern machines only operate for 10 minutes to complete the task.

When the required amount of clean water is sufficient, the machine will automatically shut off. If you see that the machine has been running for more than 2 hours without any signs of stopping, then the machine is faulty. Need to quickly check and fix to avoid wasting water and electricity consumption.

Why does the water purifier not stop running?

There are many reasons why a water purifier won’t stop running. Here are some common reasons:

  • Problems occur in high pressure valves, flow valves, solenoid valves, etc.
  • The one-way valve of the water purifier is broken
  • The machine’s water pipes have problems such as clogged, dirty, etc.
  • The filter membrane or filter core is dirty

However, we should confirm the cause more carefully and fix it properly. When detecting a machine error, you need to turn off the machine, disconnect the power and check to see what the cause of the machine error is.

One of the easiest ways to identify the cause is to observe the amount of wastewater. Due to a faulty machine, pure water does not flow into the pressure tank, so a lot of water is discharged.

The water pipe into the machine is clogged
The water pipe into the machine is clogged

Some extremely simple remedies at home

Below are some suggestions to fix the problem of water purifier running without stopping. The measures are simple and easy to do at home.

1. Handle clogged water pipes into the machine

Over time, water pipes are susceptible to dirt, residue, etc. sticking to them or becoming covered with moss. These are the reasons that hinder the flow of water, causing lack of water supply to the filter membrane, etc.

Clean the water pipes immediately. If the pipe is found to be leaky, broken, etc., it should be replaced to conduct water more effectively.

2. The phenomenon of the solenoid valve being clogged, damaged or not fully open

The solenoid valve is located behind filter cup number 2, in front of the water source entering the booster pump. This valve is responsible for controlling the amount of water entering the machine and regulating water circulation in the filter system.

Remove filter cup No. 2 of the machine to check. If you see water dripping or flowing weakly, the solenoid valve is broken. Need to start replacing the new valve or contact the warranty center for support.

3. Weak pump pressure

Weak pump pressure causes the machine to operate at insufficient capacity. This leads to the situation of not being able to push water through the machine’s filter. Check by removing the pump’s push head elbow to check the water output force. Use your hand to cover the end of the quail and keep it still for 1 to 2 minutes. If it is easily plugged and the water flows intermittently, the pump is broken. We need to repair or replace to increase efficiency.

4. The water purifier’s flow valve is broken

The flow valve is also known as the machine’s high pressure valve. This valve is responsible for automatically releasing water during the water filtration process. When the flow valve is broken, wastewater will flow out continuously, weakening the water pressure. The best solution is to replace the flow valve with a new one and re-adjust the water pressure.

The water purifier's flow valve is broken
The water purifier’s flow valve is broken

Limit the situation of the water purifier running without stopping

To limit the occurrence of the water purifier running without stopping, we need to pay attention to the following things during use:

  • Regularly check and maintain to ensure the machine is still working well.
  • Replace the filter core and membrane according to the manufacturer’s recommendations.
  • Use machines from famous brands with good warranty and support policies.
Some notes to avoid the water purifier running continuously
Some notes to avoid the water purifier running continuously

Conclude

The water purifier flows continuously is one of the basic errors that can be encountered when the machine operates. We should check to clearly determine the cause to fix it properly and ensure effectiveness.


Source link

This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *